🧱 Service

Concrete and Masonry

Concrete and Masonry in the US and Canada from Pro House Maintenance starts with a free, fixed-price estimate from a licensed, insured local crew. Typical Concrete and Masonry projects run $7–$20 per sq ft. We handle the work end to end, keep the job site clean, and don't consider it done until you're satisfied.

Free
Estimates
Licensed
& Insured
Vetted
Local pros
Site preparation and formworkReinforcement steel (rebar and wire mesh)Concrete pour and finishingMasonry block, brick, or stone laying

Structural and decorative concrete and masonry work — poured concrete slabs and footings, concrete block, brick and stone work, retaining walls, and steps.

What does Concrete and Masonry include?

  • Site preparation and formwork
  • Reinforcement steel (rebar and wire mesh)
  • Concrete pour and finishing
  • Masonry block, brick, or stone laying
  • Mortar joints, tuckpointing, and sealing
  • Retaining wall drainage and backfill

How does Concrete and Masonry work?

/01

Assessment and design

We evaluate the site, soil, and load requirements, then plan formwork, reinforcement, and mix specifications for the application.

/02

Excavation and prep

Site is excavated to proper depth, forms are set, and reinforcement steel is placed before any concrete is poured.

/03

Pour and finish

Concrete is placed, consolidated, and finished to the appropriate texture — broom, trowel, stamped, or exposed aggregate.

/04

Cure and seal

Concrete is protected during curing, then sealed for durability and stain resistance once it reaches full strength.

Concrete and masonry work demands precision in materials, reinforcement, and timing — cut corners on any one of them and you end up with cracking, spalling, or structural failure within years. Our crews are experienced in both structural work and decorative finishes, from basic flatwork to complex block retaining walls and stamped concrete patios.

Whether you’re replacing a crumbling front walk, building a retaining wall to manage a sloped yard, or pouring a new garage slab, we engineer the substrate and reinforcement correctly before the first yard of concrete arrives.

Cost

How much does Concrete and Masonry cost?

Most concrete and masonry projects run $7–$20 per sq ft. Your exact price depends on scope, materials, and site conditions — every Pro House Maintenance quote is free and fixed-price before any work begins.

Concrete and Masonry — at a glance
DetailWhat to expect
Typical cost$7–$20 per sq ft
EstimateFree, fixed-price written quote
CrewsLicensed & insured, vetted local pros
Service area50 US states + 13 Canadian provinces & territories
FinancingAvailable for qualified homeowners
FAQ

Concrete and Masonry questions, answered.

How soon can I use a new concrete slab?

Light foot traffic is typically fine after 24 to 48 hours. Vehicles should stay off for at least seven days, and concrete reaches design strength at 28 days. We seal the surface and advise on care during the curing window.

Can you repair cracked or heaving concrete?

Many cracks and heaved slabs can be repaired cost-effectively with grinding, patching, or mudjacking. Structural cracks wider than a quarter inch, slabs with multiple failure points, or heaving caused by poor sub-base typically require full replacement. We assess the underlying cause — not just the surface symptom — and give you an honest repair-versus-replace recommendation before any work begins.

Reviews

What homeowners say about concrete and masonry.

★★★★★

"Stone retaining wall and a new concrete walkway. The masonry work is exceptional — level, tight joints, no cracks after a full winter."

Frank D. · Pittsburgh, PA · Concrete & Masonry
★★★★★

"They finished our basement two days early and the inspector had zero notes. Crew was tidy and professional."

Dana R. · Austin, TX · Basement Renovation
★★★★★

"The kitchen remodel came in on budget and the project manager actually answered the phone every time I called."

Greg L. · Denver, CO · Kitchen Remodeling

Key takeaways

  • Concrete and Masonry from Pro House Maintenance starts with a free, fixed-price estimate and no obligation.
  • Typical concrete and masonry projects run $7–$20 per sq ft.
  • All crews are licensed, insured, and vetted local professionals.
  • All crews are licensed and insured.
  • Financing is available for qualified homeowners.
  • Pro House Maintenance serves homeowners across 50 US states and 13 Canadian provinces and territories.
Free estimate

Get a free concrete and masonry estimate.

Get a Quote